DIE CASTING LUBRICANT

Die casting is a casting method where molten metal is poured into a mold at high pressure and hardened. “GRAPHACE” is the die casting lubricant necessary for the separation of the heated metal from the mold. It is used on die casting machines used to cast aluminum automotive parts and magnesium parts and it contributes to the improvement of productivity and the environment.

Water-Soluble Minimum Quantity Coating Type Lubricant

MQ-500

This has adhesive properties and good releasing properties over a wide temperature range and shows good mold releasing under a wide range of conditions.

MQ-500 This has adhesive properties and good releasing properties over a wide temperature range and shows good mold releasing under a wide range of conditions.

MQ-600

The high temperature adhesion has been improved from that of MQ-500 and it even shows excellent adhesion on the high temperature parts where mold cooling is difficult.

MQ-600 The high temperature adhesion has been improved from that of MQ-500 and it even shows excellent adhesion on the high temperature parts where mold cooling is difficult.

For Zinc

HC-100

This product can be diluted in kerosene or water and has an established reputation for low mold soiling.

HC-100 This product can be diluted in kerosene or water and has an established reputation for low mold soiling.
Learn More

Water-Soluble Diluted Type (High releasing properties)

GL-3700

It shows good drying properties in the low mold temperature range and forms a strong release film. This can help shorten cycle times and reduce the amount of residual water.

GL-3700 It shows good drying properties in the low mold temperature range and forms a strong release film. This can help shorten cycle times and reduce the amount of residual water.

TX-2400

These have excellent adhesion and releasing properties and form a uniform and strong release film over a wide range of mold temperatures. This type only produces a small amount of gas, so it realizes high quality casting.

TX-2400 These have excellent adhesion and releasing properties and form a uniform and strong release film over a wide range of mold temperatures. This type only produces a small amount of gas, so it realizes high quality casting.